IDEAL CEILINGPLAST is perfect for application on concrete soffits, soffits with hourdi blocks, and AAC block walls. Normal plaster and putty can be completely avoided when using this product.
The product is a cement-based plastering system comprising of two compounds, CEILINGPLAST- BASE COAT and FINISH COAT.
Base Coat is a ready-mixed compound, formulated to be applied on a wide range of interior surfaces in skim coats of as low as 5-7 mm in thickness.
As the product is grey cement-based, the finished surface will have a cement-plastered look.
Finish Coat is a white cement-based, ready mixed compound that can be applied in coats of up to 1 mm in thickness, preferably in two layers, following the BASE COAT.
Applying this FINISH COAT avoids the need for any further wall fillers or primers prior to painting. When used for finishing ceilings, the final coat may be left spray-textured, eliminating the need for any further painting work.
Both the BASE COAT and FINISH COAT are applied manually, using steel-edged spatula or with the aid of plastering pumps for an even finish.
Application process is somewhat similar to with that of wall putty implying a skilled painter who is well versed with putty application can easily work with this product.
Advantages Of Our System
IDEAL CEILINGPLAST is suitable for both pre-cast and conventional buildings. This product can be applied directly to either new or old surfaces of pre-cast concrete, aerated concrete, sand/cement, fair-faced or level brickwork, etc.
As the product is applied with a spatula, high wastage of sand/cement render encountered in conventional ceiling plastering is totally avoided, resulting in the saving of substantial material and labour cost.
Made using Anti-Crack, Resilient Material
Due to the presence of high-quality polymers and carefully graded additives, IDEAL CEILINGPLAST is safe from cracks which can form in the case of sand/cement plaster.
Due to thin layers of application, curing can be practically avoided. Prolonged curing of normal plaster in addition to being expensive leaves the area water logged and messy below.
High Adhesive Power
Due to the presence of polymers, cement-based additives and thin layers used during application, adhesion of CEILINGPLAST is exceptionally high.
45% Lesser Dead Load
10 mm of plastering done with CEILINGPLAST will weigh approximately 18 kg/m3 whereas traditional plaster at the minimum applicable thickness of 15 mm will weigh approximately 33 kg/m3 – a weight reduction of nearly 45%!
Application is both economical and faster than conventional plaster
Since the material is pliable and hence can be applied with a regular spatula, higher daily output from painters can be achieved.